Eşyalarını Tamir Et Topluluk Mağaza

Google Pixel 4a 屏幕置换

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 11 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
Çince
Adım 6
Google Pixel 4a Screen Replacement: adım 0, 3 resimden 1. Google Pixel 4a Screen Replacement: adım 0, 3 resimden 2. Google Pixel 4a Screen Replacement: adım 0, 3 resimden 3.

  • The screen adhesive is very weak and you should not need to re-apply heat. If the screen does feel hard to slice, apply heat to the difficult area for one minute and try again.

  • Insert another opening pick into the right edge of the phone at an angle where a gap has already formed to prevent damage to the OLED panel.

  • Slide the opening pick around the bottom of the phone to cut the adhesive.

  • There is a delicate cable under the bottom-right corner of the screen. If you feel your opening pick snag on anything, pull it out and try again. Make sure your pick is angled downward and only inserted as little as is necessary to separate the adhesive (no more than 2 mm deep).

  • Leave the pick inserted along the bottom edge to prevent the adhesive from resealing.

粘胶没有那么粘，你不需要给屏幕再次加热。如果在某个位置很难插入撬片，给那里加热一分钟，然后再试一次。

在前文提到过的缝隙处插入另一个撬片来防止划伤 OLED 屏幕面板。

沿四周划开粘胶。

把撬片留在底部边缘以防止粘胶重新粘合。

[* icon_note] The screen adhesive is very weak and you should not need to re-apply heat. If the screen does feel hard to slice, apply heat to the difficult area for one minute and try again.
[* black] Insert another opening pick into the right edge of the phone at an angle where a gap has already formed to prevent damage to the OLED panel.
[* black] Slide the opening pick around the bottom of the phone to cut the adhesive.
- [* icon_caution] There is a delicate cable under the bottom-right corner of the screen. If you feel your opening pick snag on anything, pull it out and try again. Make sure your pick is angled downward and only inserted as little as is necessary to separate the adhesive (no more than 3 mm deep).
+ [* icon_caution] There is a delicate cable under the bottom-right corner of the screen. If you feel your opening pick snag on anything, pull it out and try again. Make sure your pick is angled downward and only inserted as little as is necessary to separate the adhesive (no more than 2 mm deep).
[* black] Leave the pick inserted along the bottom edge to prevent the adhesive from resealing.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.