Ana içeriğe geç

Nieuwe Elco's en elektrisch reviseren van een Direct Drive draaitafel

İngilizce
Flemenkçe

Adım 1 çevriliyor

Adım 1
"Re-cap" and Electrically Overhaul a Direct Drive Turntable, Clean potentiometers and switch contacts: adım 0, 2 resimden 1. "Re-cap" and Electrically Overhaul a Direct Drive Turntable, Clean potentiometers and switch contacts: adım 0, 2 resimden 2.
Clean potentiometers and switch contacts
  • Identify the trimmer potentiometers and spray thoroughly with contact cleaner. Use an appropriate screwdriver to turn the the potentiometer position back and fourth vigorously for a bit. This helps remove any dirt or oxidization.

  • Rotating the potentiometers will change your motor speed setting. This will have to be re-adjusted after reassembly.

  • Spray any push or slide switches with contact cleaner and operate them vigorously.

  • Let the board sit for a while, then reassemble the turntable and check for steady speed. If the speed is till unstable, or if you are not able to get a correct speed for 33 and 45rpm modes by adjusting the trimmer potentiometers, proceed further with this guide.

Identificeer de trimmerpotentiometers en spuit grondig met contactreiniger. Gebruik een geschikte schroevendraaier om de positie van de potentiometer een tijdje voorzichtig heen en weer te draaien. Dit helpt bij het verwijderen van vuil of oxidatie.

Door aan de potentiometers te draaien, verandert de instelling van uw motorsnelheid. Deze zal na montage opnieuw moeten worden afgesteld.

Spuit eventuele druk- of schuifschakelaars in met contactreiniger en bedien ze enkele keren.

Laat de contactreiniger een tijdje drogen, zet dan de draaitafel weer in elkaar en controleer op constante snelheid. Als de snelheid nog steeds onstabiel is, of als u niet in staat bent om de juiste snelheid voor 33 en 45 rpm te krijgen door de trimmerpotentiometers aan te passen, ga dan verder met deze handleiding.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.