Ana içeriğe geç

Cómo usar grapas de sujeción a tornillo

İngilizce
İspanyolca

Adım 5 çevriliyor

Adım 5
How To Use Screen Vise Clamps: adım 0, 3 resimden 1. How To Use Screen Vise Clamps: adım 0, 3 resimden 2. How To Use Screen Vise Clamps: adım 0, 3 resimden 3.
  • Repeat the previous steps for the five remaining vise clamps: one at each of the four corners, and one in the middle of each long edge.

  • For larger tablets, more than six vise clamps may be needed to ensure the adhesive bonds evenly around the entire perimeter.

  • Using a hair dryer or heat gun, evenly heat the edges all the way around the device until they are slightly too hot to touch. The heat will help the adhesive form a more complete bond.

  • Don't overheat the device, or you may cause the battery to ignite or damage other heat-sensitive components, like the display.

  • While the device is still hot, tighten all six vise clamps down one full turn.

  • Don't tighten any further to avoid damaging your device.

  • Leave the vise clamps in place for about thirty minutes.

Repite los pasos anteriores para las cinco grapas restantes: una en cada una de las cuatro esquinas y una en el centro de cada borde largo.

En el caso de las tabletas más grandes, es posible que se necesiten más de seis grapas para garantizar que el adhesivo se adhiera de manera uniforme en todo el perímetro.

Con un secador de pelo o una pistola de calor, calienta uniformemente los bordes alrededor del dispositivo hasta que estén demasiado calientes para tocarlos. El calor ayudará a que el adhesivo se adhiera de forma más completa.

No sobrecalientes el dispositivo, o puedes hacer que la batería se encienda o dañar otros componentes sensibles al calor, como la pantalla.

Mientras el dispositivo está todavía caliente, aprieta las seis grapas una vuelta completa.

No aprietes más para no dañar el dispositivo.

Deja las grapas en su sitio durante unos treinta minutos.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.