Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

İngilizce
Japonca
Adım 6
Our 2.5 mm nut driver makes a rare appearance (you may remember its role in the iPhone 6s Teardown)—removing logic board standoff screws. Thanks to our iPhone Marlin kit, we're covered! Good to see incredibly-thin computers opting for screws over glues. Hey, iPad team, take note? The fanless M1 MacBook Air-sized logic board is housed in the artificial "chin" of the iMac.
  • Our 2.5 mm nut driver makes a rare appearance (you may remember its role in the iPhone 6s Teardown)—removing logic board standoff screws. Thanks to our iPhone Marlin kit, we're covered!

  • Good to see incredibly-thin computers opting for screws over glues. Hey, iPad team, take note?

  • The fanless M1 MacBook Air-sized logic board is housed in the artificial "chin" of the iMac.

  • Unlike the one in the MacBook Air, this M1 is actively cooled by a pair of fans. Each fan blows inward across the logic board, where the heatsink draws heat away from the M1 with a copper heat pipe and two short heatsinks.

  • We'll circle back later for a closer look at those fans, but we can't resist a bare logic board!

iPhone 6sの分解で大活躍した2.5mmのナットドライバーが珍しく登場して、ロジックボードのスタンドオフネジを外します。iPhone用Marlin kitがあれば、問題ありません!

これほど薄型のコンピュータで、接着剤の代わりにネジが使用されているのは素晴らしいことです。いいですか、iPadチームの皆さん、ここは覚え書きしてください。

ファンレスのM1 MacBook Airサイズのロジックボードは、iMacの顎に当たる部分に搭載されています。

MacBook Airに搭載されているロジックボードとは異なり、このM1モデルは両側のファンで効果的に冷却します。ファンはロジックボード内側に向けて吹き付け、ヒートシンクはコッパー製のヒートパイプと2つの短いヒートシンクでM1からの熱を吸収します。

ファンについては後ほど詳しくご紹介しますが、ロジックボードが目の前にあるので、次の作業に移りましょう。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.