3D Raptor V1.1 Linear Rail Kit Install

İngilizce

Japonca

Önceki adım Sonraki adım

Adım 2 çevriliyor

Adım 2

3D Raptor V1.1 Linear Rail Kit Install, Disassembly 1b.: adım 0, 3 resimden 1.

3D Raptor V1.1 Linear Rail Kit Install, Disassembly 1b.: adım 0, 3 resimden 2.

3D Raptor V1.1 Linear Rail Kit Install, Disassembly 1b.: adım 0, 3 resimden 3.

Disassembly 1b.

The X Axis assembly is attached to the X/Z trolleys with 4 M4 cap screws and T nuts.
Unplug the X End Stop then the X Motor (this can be done before or after X Axis removal depending on your access)
Remove the assembly by loosening the cap screws from the back of the machine. The T nuts just need to align parallel to the slot.
Hold on to the X Axis assembly with one hand. If not, it will fall onto the bed.
Be sure the X Motor is unplugged

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.