Ana içeriğe geç

Reemplazo del cristal trasero del iPhone 15 Pro Max

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

İngilizce
İspanyolca
Adım 4
iPhone 15 Pro Max Back Glass Replacement, Insert an opening pick: adım 0, 2 resimden 1. iPhone 15 Pro Max Back Glass Replacement, Insert an opening pick: adım 0, 2 resimden 2.
Insert an opening pick
  • Use a hair dryer or heat gun to heat the bottom edge of the back glass until it's hot to the touch.

  • Be careful not to heat the phone hotter than this—the battery is susceptible to heat damage.

  • Wait up to a minute for the adhesive to separate and a gap to form between the back glass and the frame.

  • If a gap doesn't appear after one minute, apply more heat and rotate the handle a quarter turn. Let the Anti-Clamp and time do the work for you.

  • Insert an opening pick into the gap.

  • Remove the Anti-Clamp using the pull tabs on the suction cups.

  • Skip the next two steps.

Use un secador de pelo o una pistola de calor para calentar el borde inferior del vidrio trasero hasta que esté caliente al tacto.

Tenga cuidado de no calentar el teléfono más que esto: la batería es susceptible a daños por calor.

Espere hasta un minuto para que el adhesivo se separe y se forme un espacio entre el vidrio trasero y el marco.

Si no aparece un espacio después de un minuto, aplique más calor y gire la manija un cuarto de vuelta. Deje que el Anti-Clamp y el tiempo hagan el trabajo por usted.

Inserta una púa de apertura en el espacio.

Retire el Anti-Clamp usando las lengüetas de las ventosas.

Omita los siguientes dos pasos.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.