Ana içeriğe geç

Steam Deck OLED バッテリーの再接続(相互接続ケーブルなし)

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 9 kılavuzları etkileyecektir.

İngilizce
Japonca

Adım 3 çevriliyor

Adım 3
Steam Deck OLED Battery Reconnection (No Interconnect Cable), Reassembly instructions: adım 0, 3 resimden 1. Steam Deck OLED Battery Reconnection (No Interconnect Cable), Reassembly instructions: adım 0, 3 resimden 2. Steam Deck OLED Battery Reconnection (No Interconnect Cable), Reassembly instructions: adım 0, 3 resimden 3.
Reassembly instructions
  • During reassembly, follow this step and the above three steps to reconnect the battery.

  • Use your T6 Torx driver to remove the two 3.8 mm‑long screws securing the motherboard shield.

  • Lift the top edge of the motherboard shield up and flip it over the bottom edge of the frame, away from the motherboard.

  • Be careful not to crease or strain the cable.

再組み立ての際は、この手順と上記の3つの手順に従ってバッテリーを再接続してください。

T6トルクスドライバーを使用して、マザーボードシールドを固定している長さ3.8mmのネジ2本を取り外します。

マザーボードシールドの上端を持ち上げ、マザーボードから離してフレームの下端にかぶせます。

ケーブルに折り目をつけたり、引っ張ったりしないように注意してください。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.