Eşyalarını Tamir Et Topluluk Mağaza

Reemplazo del ensamblaje del panel frontal del iPhone 5s

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 32 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
İspanyolca
Adım 5
iPhone 5s Front Panel Assembly Replacement: adım 0, 3 resimden 1. iPhone 5s Front Panel Assembly Replacement: adım 0, 3 resimden 2. iPhone 5s Front Panel Assembly Replacement: adım 0, 3 resimden 3.

  • Pull the blue handle forwards to lock the arms.

  • Turn the handle clockwise 360 degrees or until the cups start to stretch.

  • Make sure the suction cups remain aligned with each other. If they begin to slip out of alignment, loosen the suction cups slightly and realign the arms.

  • Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time and wait a few seconds between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next two steps.

Tira de la empuñadura azul hacia delante para bloquear los brazos.

Gira la manija 360 grados en sentido horario, o hasta que las ventosas comiencen a estirarse.

Asegúrate de que las ventosas permanezcan alineadas entre sí. Si comienzan a desalinearse, libera las ventosas ligeramente y realinea las abrazaderas.

Inserta una herramienta de apertura bajo la pantalla cuando el Anti-Clamp cree un agujero lo suficientemente amplio como para hacerlo.

Si el Anti-Clamp no puede generar un espacio suficiente, rota la manija un cuarto de giro.

No gires la manija más de un cuarto de giro y espera unos segundos entre giro y giro. Deja que el Anti-Clamp haga su trabajo dándole tiempo.

Salta los próximos dos pasos.

[* black] Pull the blue handle forwards to lock the arms.
[* black] Turn the handle clockwise 360 degrees or until the cups start to stretch.
[* icon_note] Make sure the suction cups [link|https://guide-images.cdn.ifixit.com/igi/BSluctHhVVqhGtfj.full|remain aligned with each other|new_window=true]. If they begin to slip out of alignment, loosen the suction cups slightly and realign the arms.
-[* black] Insert an opening tool under the screen when the Anti-Clamp creates a large enough gap.
+[* black] Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap.
[* icon_note] If the Anti-Clamp doesn't create a sufficient gap, rotate the handle a quarter turn.
[* icon_caution] ***Don't crank more than a quarter turn at a time and wait a few seconds between turns***. Let the Anti-Clamp and time do the work for you.
[* black] ***Skip the next two steps.***

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.