Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 9 kılavuzları etkileyecektir.

İngilizce
Japonca

Adım 13 çevriliyor

Adım 13
Now that the lower edge of the board is free from the outer case, rotate the logic board toward yourself to expose its rear face. The following connector has a tendency to stick in its socket. If so, insert a metal spudger into the gap between the connecter and its socket. Twist the spudger to separate the two components.
  • Now that the lower edge of the board is free from the outer case, rotate the logic board toward yourself to expose its rear face.

  • The following connector has a tendency to stick in its socket. If so, insert a metal spudger into the gap between the connecter and its socket. Twist the spudger to separate the two components.

  • Carefully pull the optical drive connector away from its socket on the logic board.

  • Pull the connector perpendicular to the face of the logic board.

ボードの下側端がアウターケースから外れます。ロジックボードを自分の方に向けて回転させて背面を露出させます。

次のコネクタはそのソケットにくっついてしまう傾向があります。 その場合は、コネクタとそのソケットの間の隙間に金属スパッジャーを挿入します。 スパッジャーをひねりながら、この2つを離します。

光学ドライブコネクタをロジックボードのソケットから慎重に引き抜きます。

ロジックボードの面に対して垂直にコネクタを引きます。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.