Eşyalarını Tamir Et Topluluk Mağaza

Remplacement de la porte d'accès à la batterie du Samsung S85

Adım 1 çevriliyor

Kılavuza Dön
İngilizce
Fransızca
Adım 1
Samsung S85 Battery Door Replacement: adım 0, 3 resimden 1. Samsung S85 Battery Door Replacement: adım 0, 3 resimden 2. Samsung S85 Battery Door Replacement: adım 0, 3 resimden 3.

  • Rotate camera such that battery door is facing upwards. Open battery as if you normally would when changing batteries

  • Bend paperclip such that metal is now a thin rod

  • Align rod portion of paperclip with pin located at bottom of battery door. Gently push on pin with rod such that rod replaces pin underneath battery door as shown in first picture

  • Be careful with spring located with pin as this may fly off when being pushed out by paperclip.

  • Using tweezers, gently pull pin out from opposite end of paperclip. When pin is fully removed, remove paper clip.

  • Battery door should now be fully removed from battery slot.

Faites pivoter l'appareil photo de manière à ce que le couvercle de la batterie soit orienté vers le haut. Ouvrez la batterie comme si vous le feriez normalement lors du changement de batterie

Pliez le trombone de telle sorte que le métal soit maintenant une fine tige

Alignez la tige du trombone avec la broche située au bas du couvercle du compartiment de la batterie. Poussez doucement sur la goupille avec la tige de sorte que la tige remplace la goupille sous le couvercle de la batterie comme indiqué sur la première image

Soyez prudent avec le ressort situé avec la goupille car il peut s'envoler lorsqu'il est poussé par un trombone.

À l'aide d'une pince à épiler, retirez délicatement la goupille de l'extrémité opposée du trombone. Lorsque la goupille est complètement retirée, retirez le trombone.

La porte de la batterie doit maintenant être complètement retirée du logement de la batterie.

[* black] Rotate camera such that battery door is facing upwards. Open battery as if you normally would when changing batteries
[* black] Bend paperclip such that metal is now a thin rod
[* blue] Align rod portion of paperclip with pin located at bottom of battery door. Gently push on pin with rod such that rod replaces pin underneath battery door as shown in first picture
[* icon_caution] Be careful with spring located with pin as this may fly off when being pushed out by paperclip.
-[* red] Using tweezers, gently pull pin out from opposite end of paperclip. When pin is fully removed, remove paper clip.
+[* red] Using [product|IF145-020|tweezers], gently pull pin out from opposite end of paperclip. When pin is fully removed, remove paper clip.
[* black] Battery door should now be fully removed from battery slot.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.