Skip to main content

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 8 kılavuzları etkileyecektir.

İngilizce
Japonca

Adım 24 çevriliyor

Step 24
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.

これから出てくる幾つかの手順を完成させるには、常に接着剤が柔らかくなっているか確認をしてからロジックボードに留められた接着剤をこじ開ける作業を始めてください。柔らかくなっていない場合は、iOpener を再度温めて、背面ケースの裏側にあててください。

正面カメラとバッテリーの間のロジックボードの底に開封ピックをゆっくりと差し込みます。

ピックを正面カメラコネクター側にスライドさせます。そして、ロジックボードのベンドの箇所で止めます。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.