Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 10 kılavuzları etkileyecektir.

İngilizce
İtalyanca
Adım 4
Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board. To reduce the risk of a short, you can use a battery isolation pick to isolate the battery. The battery isolation pick or battery blocker is an outdated way of isolating the battery, as you risk damaging the battery pins underneath the logic board. If you use this method, take extreme care to insert it gently and straight in the direction of the logic board. Do not twist or swing the pick side to side.
  • Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board.

  • To reduce the risk of a short, you can use a battery isolation pick to isolate the battery.

  • The battery isolation pick or battery blocker is an outdated way of isolating the battery, as you risk damaging the battery pins underneath the logic board. If you use this method, take extreme care to insert it gently and straight in the direction of the logic board. Do not twist or swing the pick side to side.

  • Slide a battery isolation pick underneath the battery connector area of the logic board, and leave it in place while you work.

Çeviri buraya girin

Çeviri buraya girin

Çeviri buraya girin

Çeviri buraya girin

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.