Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 10 kılavuzları etkileyecektir.

İngilizce
Japonca
Adım 4
Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board. Make a battery blocker using a playing card and slide it underneath the logic board connector to disconnect the battery. You can also use an iFixit battery blocker. Be very careful and don't push the battery blocker underneath the connector with excessive force.
  • Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board.

  • Make a battery blocker using a playing card and slide it underneath the logic board connector to disconnect the battery.

  • You can also use an iFixit battery blocker. Be very careful and don't push the battery blocker underneath the connector with excessive force.

  • Leave the blocker there to prevent the battery connector leads from making contact until you have completed your repairs.

ロジックボードに留められたバッテリーコネクターから2.3 mmプラスネジを1本、取り外します。

ショートの危険を減らすため、バッテリー絶縁ピックを使って、バッテリーを絶縁します。

バッテリーの絶縁ピックやバッテリーブロッカーを使用してバッテリーを絶縁する方法は古いやり方となりました。ロジックボードの下にあるバッテリーピンを破損してしまうリスクがあるためです。この方法で作業を進める場合、ピックもしくはブロッカーをロジックボードの方向にまっすぐ、慎重に差し込んでください。ピックをコネクタの端から端までひねったり動かさず、まっすぐ差し込みます。

バッテリー分離ピックをロジックボードのバッテリーコネクターの下に差し込み、作業中はそのままにしておいてください。

[* red] Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board.
-[* icon_note] To reduce the risk of a short, you can use a battery isolation pick to isolate the battery.
-[* icon_caution] The battery isolation pick or battery blocker is an outdated way of isolating the battery, as you risk damaging the battery pins underneath the logic board. If you use this method, take extreme care to insert it gently and straight in the direction of the logic board. Do not twist or swing the pick side to side.
- [* black] Slide a battery isolation pick underneath the battery connector area of the logic board, and leave it in place while you work.
+[* icon_note] [guide|143682|Make a battery blocker using a playing card|new_window=true] and slide it underneath the logic board connector to disconnect the battery.
+ [* icon_caution] You can also use an iFixit battery blocker. Be very careful and don't push the battery blocker underneath the connector with excessive force.
+[* black] Leave the blocker there to prevent the battery connector leads from making contact until you have completed your repairs.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.