Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 7 kılavuzları etkileyecektir.

İngilizce
Fransızca

Adım 1 çevriliyor

Adım 1
Use the flat end of a spudger to lift the right fan connector out of its socket on the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.
  • Use the flat end of a spudger to lift the right fan connector out of its socket on the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

Utilisez l'extrémité plate d'un spudger pour soulever le connecteur du ventilateur droit hors de sa prise sur la carte mère.

Il est utile de faire pivoter le spudger sous les câbles du ventilateur pour débrancher le connecteur.

La deuxième et la troisième photo montrent respectivement la prise et le connecteur du ventilateur. Veillez à ne pas casser la prise en plastique lorsque vous soulevez le connecteur avec votre spudger. La carte mère représentée sur la deuxième photo peut être légèrement différente de celle de votre machine, mais la prise reste identique.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.