Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

İngilizce
Almanca

Adım 17 çevriliyor

Adım 17
Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals. Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.
  • Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.

  • Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.

  • If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

Während des nachfolgend beschriebenen Verfahrens, wirst du dünne Plastikkarten zwischen Akku und Gehäuse schieben, um den Kleber zu trennen, mit dem der Akku am Gehäuse befestigt ist. Achte darauf, die Karten so flach wie möglich zu halten, und vermeide es, den Akku zu verbiegen. Dies könnte ihn beschädigen und gefährliche Chemikalien freisetzen.

Drehe das iPad um und setze eine Plastikkarte zwischen Rückgehäuse und der Seite des Akkus direkt am Logic Board und am Lautsprecher ein.

Wenn du deutlichen Widerstand verspürst, musst du den iOpener nochmals erwärmen und den vorigen Schritt wiederholen, damit dem Kleber mehr Zeit zum Aufweichen bleibt.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.