Ana içeriğe geç

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

İngilizce
Fransızca

Adım 31 çevriliyor

Adım 31
The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself. Carefully insert an opening pick under the ribbon cable near the Lighting connector housing.
  • The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself.

  • Carefully insert an opening pick under the ribbon cable near the Lighting connector housing.

  • Slide the opening pick toward the logic board, but stop half an inch from the bend in the cable.

  • Continuing farther along the ribbon cable risks cutting it.

La nappe du connecteur de charge Lightning est collée à la coque avec de l'adhésif. Pour détacher l'adhésif, vous glisserez un médiator entre la nappe et la coque. Veillez à ne pas couper la nappe même du connecteur de charge Lightning.

Insérez délicatement un médiator sous la nappe près du boîtier du connecteur de charge Lightning.

Faites glisser le médiator vers la carte mère, mais arrêtez à un 1,2 cm du coude de la nappe.

Avancer plus risque de couper la nappe.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.