Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Uyarı: Az önce incelediğiniz kılavuzun bir önkoşulunu düzenlemektesiniz. Yapacağınız herhangi bir değişiklik bu adımı içinde bulunduran 7kılavuzları etkileyecektir.

İngilizce
İspanyolca
Adım 2
Carefully insert a small flathead screwdriver or Jimmy in the seam between the metal casing and white plastic top. Use the screwdriver to pry up the white plastic top bezel. Be careful not to damage the soft plastic with your screwdriver.
  • Carefully insert a small flathead screwdriver or Jimmy in the seam between the metal casing and white plastic top. Use the screwdriver to pry up the white plastic top bezel. Be careful not to damage the soft plastic with your screwdriver.

  • The top bezel is held on with an adhesive, so it may be necessary to pry up in several different locations to free the part.

  • To make this job easier, heat up the adhesive with a hairdryer on low heat for a few seconds.

Con cuidado, inserta un destornillador plano pequeño en la costura entre la carcasa de metal y la tapa de plástico blanco. Utiliza el destornillador para levantar el bisel superior de plástico blanco. Ten cuidado de no dañar el plástico blando con el destornillador.

El bisel superior se sujeta con un adhesivo, por lo que puede ser necesario hacer palanca en varios lugares diferentes para liberar la pieza.

Para facilitar este trabajo, calienta el adhesivo con un secador a fuego lento durante unos segundos.

[* black] Carefully insert a small flathead screwdriver or [product|IF145-259|Jimmy] in the seam between the metal casing and white plastic top. Use the screwdriver to pry up the white plastic top bezel. Be careful not to damage the soft plastic with your screwdriver.
[* black] Carefully insert a small flathead screwdriver or [product|IF145-259|Jimmy] in the seam between the metal casing and white plastic top. Use the screwdriver to pry up the white plastic top bezel. Be careful not to damage the soft plastic with your screwdriver.
[* icon_note] The top bezel is held on with an adhesive, so it may be necessary to pry up in several different locations to free the part.
[* black] To make this job easier, heat up the adhesive with a hairdryer on low heat for a few seconds.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.