5 LED 6 Mode Rear Bike Light LED Replacement

İngilizce

Japonca

Adım 3 çevriliyor

Adım 3

Insert New LED

Place the new LED through the open holes
The LED should cover the schematic symbol on the circuit board and the flat edge of the LED should line up with the tip of the diode symbol shown by the arrow
If the LED does not stay, you can tape it in place on the opposite side of the board
Warm up the trace on the circuit board and the LED lead with the soldering iron
Wipe your soldering iron on the damp sponge every time you pick it up
Apply solder to the lead until the hole completely fills with solder

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.