Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 14 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
Fransızca
Önceki adım Sonraki adım

Adım 11 çevriliyor

Adım 11
Remove the following 8 screws:

  • Remove the following 8 screws:

  • Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.

  • Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

  • One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

  • Note for re-assembly:

  • The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

  • Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

Retirez les 8 vis suivantes:

Cinq vis cruciformes #00 de 2,3 mm à filetage partiel, qui attachent la carte mère au boîtier arrière.

Deux vis cruciformes #00 de 2,3 mm à filetage total, qui maintiennent la carte mère et la caméra.

Une vis cruciforme #00 de 2,9 mm sous le sticker "Do not remove".

Remarque pour le remontage:

La vis qui est placée près de la camera (en bas à droite en orange) dispose aussi d'une bande métallique qui maintient la caméra en place.

N'oubliez pas de remettre cette bande avant de réinsérer la vis cruciforme #00 de 2,3 mm à filetage total près de la caméra.

[* black] Remove the following 8 screws:
[* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
[* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screwsscrew with full thread next to the camera
[* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screwsscrew with full thread next to the camera

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.