Eşyalarını Tamir Et Topluluk Mağaza

iPod第五代（视频版）外壳更换

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 13 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
Çince
Adım 6
iPod 5th Generation (Video) Case Replacement: adım 0, 2 resimden 1. iPod 5th Generation (Video) Case Replacement: adım 0, 2 resimden 2.

  • Use angled tweezers or an iPod opening tool to slide up the brown connector latch, holding the orange battery ribbon cable in place. Make sure you pull from both sides of the latch. You only need to lift the brown connector latch up about 1-2mm to free the cable. Do not lift more or remove the latch, or you might pull the white connector with it!

  • Don't lift up too far or you could pull the battery connector out of the logic board.

  • Make sure to slide the brown connector directly upwards. The connector is frail and will break if it is accidentally shifted to the side. The connector has hooks at the bottom to hold the cable in place. As soon as you break one of the arms you will have problems putting the battery cable back on. If it breaks put the cable in the slot and then push the brown holder in place to keep the cable from slipping out.

  • Remove the cable from the connector.

使用斜角镊子或iPod开口工具向上滑动棕色连接器闩锁，将橙色电池带电缆固定到位。 确保你从锁的两侧拉。 只需将棕色连接器闩锁抬起约1-2mm即可挑起电缆。 请勿抬起或取下闩锁，否则可能会拉出白色连接器

不要抬起太多，否则可能会将电池连接器从主板中拔出。

确保直接向上滑动棕色连接器。 连接器很脆弱，如果意外地移到侧面，会断开连接。 连接器的底部有挂钩，用于固定电缆。 一旦你折断了其中一只，你将会遇到麻烦，请重新安装电池电缆。 如果断开，将电缆插入插槽，然后将棕色支撑架推到位以防止电缆滑出。

从连接器上拔下电缆。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.