Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 2 kılavuzları etkileyecektir.
Adım 2 çevriliyor
Adım 2
-
After removing the ribbon cables, take note of the screws holding the motherboard into the main chassis of the camera.
-
There are two types of screws to remove. The four (2mm, PH00) circled in red have a fat head, and go in the gold contact.
-
The three (4mm, PH00) screws marked in green have a skinny head.
-
Use the IFIXIT screwdriver and PH0 bit to remove all the screws holding the motherboard.
Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.