Ana içeriğe geç

Mac mini Mid 2011アンテナプレート交換

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 27 kılavuzları etkileyecektir.

İngilizce
Japonca

Adım 1 çevriliyor

Adım 1
Mac mini Mid 2011 Antenna Plate Replacement: adım 0, 1 resimden 1.
  • Remove the following screws securing the antenna plate to the mini:

  • Two 6.6 mm T8 Torx screws

  • Two 5.0 mm T8 Torx or 2.0 mm Hex screws (either screwdriver will work)

  • When putting back together:

  • It can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. If the screw holes don't line up with those on the hard drive, make sure that the two pins that are in the back of the hard drive are properly seated in the holes at the back of the case, above the housing for the second hard drive.

  • The antenna attaches directly to the hard drive (red markers), therefore attaching the antenna can move the hard drive around and loosen the connection of the hard drive cable to the logic board.

下記のアンテナプレートを固定している次のネジを外します:

2本の6.6 mm T8 トルクスネジ

2本の5.0 mm T8 トルクスネジ(スクリュードライバーでも可)

再組み立ての際には:

アンテナプレートを正しい位置に装着しなければ、ハードディスクドライブを正しい位置で固定するのが難しくなります。ネジの穴がハードドライブ上のネジ穴に揃わない場合、ハードドライブ裏の2つのピンがケースの裏、セカンドハードディスクのハウジング上の穴にきちんと入っているか確認してください。

アンテナはハードドライブ(赤印)に直接取り付けられているため、アンテナの取り付けがハードドライブを動かしロジックボードとのケーブル接続を緩める事があります。

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.