Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

İngilizce
Almanca
Adım 5
Once you have confirmed that the paper will apply the necessary pressure, you can then put the screws back in.
Closing
  • Once you have confirmed that the paper will apply the necessary pressure, you can then put the screws back in.

  • If the case doesn't seem to close properly as it did before, do not keep on trying to tighten the screw down; you will strip the screw.

  • If the case doesn't close properly, you will need to open the device back up and remove a tiny bit of the paper until it does close, that way it will retain its water resistance.

Nachdem du geprüft hast, dass das Papier den notwendigen Druck aufbaut, verschließe die Schrauben wieder.

Falls das Gehäuse nicht so gut schließt wie zuvor, wende keine Gewalt an, die Schrauben einzuschrauben.

In diesem Fall öffne die Geräterückseite wieder und entferne ein kleines bisschen Papier, bis das Gehäuse schließt. So bleibt es wasserresistent.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.