Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

İngilizce
Çince
Adım 6
Lift the brown holding tab up on the connector (Image 1 orange arrows) The ribbon only has writing on one side, that side needs to face towards the clear plastic sensor on the other end of the board
Reseating Ribbon Cable Part 2
  • Lift the brown holding tab up on the connector (Image 1 orange arrows)

  • The ribbon only has writing on one side, that side needs to face towards the clear plastic sensor on the other end of the board

  • Feed it into the connector and while holding it in place with your finger and thumb in the centre of the ribbon cable, push each side of the brown connector tab down until the connector grips the ribbon cable

  • You should notice the tops of the metallic strips/pins stuck out the top of the connector should be uniform (Image 2). If you have put it in incorrectly, then there will be more of the strips/pins showing at one end or the strips will not be visible because it is in backwards

Çeviri buraya girin

Çeviri buraya girin

Çeviri buraya girin

Çeviri buraya girin

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.