Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 9 kılavuzları etkileyecektir.

Kılavuza Dön
İngilizce
İspanyolca
Adım 2
Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen. Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

  • Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.

  • Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

  • In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.

  • Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

Usa un ISclack o un mango de ventosa para separar la unidad de pantalla del panel trasero.

No remuevas el panel trasero completamente aun. Hay un cable conectado al panel. Va desde el sensor de huella digital hasta la unidad de pantalla.

[* icon_caution] Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
[* black] Use an iSclack or a suction handle to separate the display unitphone assembly from the rear panel.
[* icon_note] In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
[* icon_caution] Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
[* black] Use an iSclack or a suction handle to separate the display unitphone assembly from the rear panel.
[* icon_note] In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
[* icon_caution] Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.