Head Cleaning v3

Adım 1 — Setting Up the Printer

With the printer switched on, access the menu screen and select the option "Quick Configuration".

Adım 2 — Repositing table

When the table reach the position indicated in the picture, press the Reset button on the left side of the machine as shown.

Adım 3 — Repositioning the head

With the table in position push the head manually toward the machine center in order to obtain an easy handling.

Adım 4 — Removing the nozzle

Position the 17mm Fixed Key as indicated in the picture, locking the inner part of the head to prevent the nozzle head from turning.

Adım 5 — Removing the upper PTFE

With your hands, pull out the PTFE tube from the printhead by pressing the black piece of the part where the tube is seated

Adım 6 — Removing the inner PTFE

By positioning the drill bit into the indicated hole, push it down until the inner PTFE comes out from under the head (where the nozzle hole is).

Adım 7 — Replacement and cleaning

Finish removing the inner PTFE and replace it with a new one or clean it.

Adım 8 — Reassembling the head

Replace the nozzle at the bottom of the printhead and the PTFE at the top, pushing it all the way with your hands.

Adım 9 — Returning the table to start position

Reposition the table in the "Home XYZ" menu option in the fast settings section and wait until it is in the position indicated by the figure