Geberit toilet flush (old model) replacement of the seal

Adım 1 — Remove cover (flush-mounted model)

Lift pressure plate from bottom to top, then remove

Adım 2 — Surface model

Grab left and right and pull up quite vigorously.

Adım 3

Be sure to turn off the water inlet, e.g. at this corner tap.

Adım 4 — The valve

The filling valve. Photo 1 with the surface box.

Adım 5 — Disconnect water inlet

With a water pump pliers, you loosen the union nut on the valve. So it is separated from the water inlet.

Adım 6 — Lift out the valve

With the surface-mounted box you can simply push the valve upwards.

Adım 7

Here you can see the parts of the valve. The seal is the red dot!

Adım 8

Now the seal has to be removed and replaced. It is sometimes difficult to find out. Try a small screwdriver.

Adım 9

When reassembling you have to make sure that the release lever engages correctly again. Use a screwdriver if necessary.