Eşyalarını Tamir Et Topluluk Mağaza

Modificación LED + Sin interruptores de Super Nintendo 50/60 Hz

Kılavuza Dön
İngilizce
İspanyolca
Önceki adım Sonraki adım

Adım 13 çevriliyor

Adım 13
Super Nintendo 50/60 Hz Switchless Mod + LED Mod, Led Resistors: adım 0, 3 resimden 1. Super Nintendo 50/60 Hz Switchless Mod + LED Mod, Led Resistors: adım 0, 3 resimden 2. Super Nintendo 50/60 Hz Switchless Mod + LED Mod, Led Resistors: adım 0, 3 resimden 3.
Led Resistors

  • Solder 2 wires on the left and right pins on the led light, green wire on the left pin and red wire on the right pin.

  • After that you should put the wires into one heat shrink tube each, remember to heat the heat shrink tubes when its over the pins.

  • Then you have to solder the 2k Resistor to the red wire and the 220 ohm Resistor to the green wire.

  • Then the last thing you need to do is to solder a wire from Super CIC Pin 7 to Pin 14.

Resistores Led

Suelda 2 cables en los pines izquierdos y derechos en la luz led, cable verde en el pin izquierdo y cable rojo en el pin derecho.

Después, debes poner cada cable en un tubo termo contraíble, recuerda calentar los tubos termo contraíbles cuando estén sobre los pines.

Después tienes que soldar la resistencia de 2k al cable rojo y la resistencia de 220 ohm al cable verde.

Después la última cosa que tienes que hacer es soldar un cable del Pin 7 Super CIC al Pin 14.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.