Giriş

A simple look into the Universal Dock

Need a flat nose screw driver 2.4mm

philip screw driver #1

Bu teardown bir tamir kılavuzu değildir. Apple Universal Dock Model A1256 cihazınızı onarmak için, servis kılavuzumuzu kullanın.

Pry along the edge of the bottom of the case. It will just pop out.
  • Pry along the edge of the bottom of the case. It will just pop out.

Yorum Ekle

Remove the top case from the bottom.
  • Remove the top case from the bottom.

Yorum Ekle

There are five Phillips screws holding the metal brace down (In the picture I have already removed them).
  • There are five Phillips screws holding the metal brace down (In the picture I have already removed them).

Yorum Ekle

The brace is glued in near the ir-sensor. You may have to apply a little bit force to remove it, but it will come out with just pulling. (You can pry it a little bit with a spudger or a screwdriver) The brace is glued in near the ir-sensor. You may have to apply a little bit force to remove it, but it will come out with just pulling. (You can pry it a little bit with a spudger or a screwdriver)
  • The brace is glued in near the ir-sensor. You may have to apply a little bit force to remove it, but it will come out with just pulling. (You can pry it a little bit with a spudger or a screwdriver)

Yorum Ekle

The only major chip located on the circuit board. (All those who have wondered about the dock's line out, I think we are clear now.) The only major chip located on the circuit board. (All those who have wondered about the dock's line out, I think we are clear now.)
  • The only major chip located on the circuit board. (All those who have wondered about the dock's line out, I think we are clear now.)

Yorum Ekle

Devilac

Üyelik tarihi: 23-06-2010

67 İtibar

1 Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 21

Her zaman: 22,007