Unscrew the top four screws.

Why would they do that?

Take off the plate that you unscrewed last step

Unscrew the four screws on the next plate.

4- take off the top plate by lifting the back up and lightly pulling up.

the picture to the left is what it looks like after you take the plate off.

5-flip over and push the side tabs in and lift the bottom piece off (it might be hard to do but try not to force it off).

6-push piece down and slide the disk piece out.

7-what is would look like.

8-unscrew the three screws on the spin piece.

9- unclip the chip in the front/back then lightly lift the piece up.

to put this device back together just do the steps backwards, nothing is hard to do.