Eşyalarını Tamir Et Topluluk Mağaza

Eufy Video Doorbell 2k (Battery-Powered) Teardown

Yazan: Muzaffar (ve bir diğer katılımcı)
Yayımlama: December 3, 2022
  • Yorumlar: 9
  • Favoriler: 0
  • Görüntülenme: 3,2b

Eufy Video Doorbell 2k (Battery-Powered) Teardown

Yazan: Muzaffar (ve bir diğer katılımcı)
Yayımlama: December 3, 2022
  • Yorumlar: 9
  • Favoriler: 0
  • Görüntülenme: 3,2b

Sökmek

Giriş

Eufy Video Doorbell 2K (Battery-Powered) a doorbell security camera that can be installed outdoors. Unfortunately for my unit, water got inside and fried a chip rendering the unit inoperable after 2 years of service. Since Eufy does not have a repair centre here in Malaysia, I decided to open it up and take a look inside.

note: Most of the images I took was is Portrait, thus images might be slightly weird or looks like it was rotated to the left.

Bu teardown bir tamir kılavuzu değildir. Eufy Doorbell 2k (Battery-Powered) cihazınızı onarmak için, servis kılavuzumuzu kullanın.

  1. Eufy Video Doorbell 2k (Battery-Powered) Teardown, Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 1, 1 resimden 1.

    • Using Phillips 000 screw driver remove 8 screws at the back.

    Düzenle

  2. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 2, 1 resimden 1.

    • Using a metal or plastic prying tool, insert it in between the seems. Then carefully lift the back unit out. Once one side is open simply lift it out from the front cover.

    Düzenle

  3. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 3, 3 resimden 1. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 3, 3 resimden 2. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 3, 3 resimden 3.

    • Battery is connected to the main board. Using a tweezer remove the battery connector.

    Düzenle

  5. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 4, 1 resimden 1.

    • Water manage to get into my unit and fried this chip. Suggest you use a rain cover if this doorbell is expose to weather outdoors. There are a lot of 3D printed rain covers for this doorbell.

    Düzenle

  6. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 5, 2 resimden 1. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 5, 2 resimden 2.

    • Remove 4 screws with a Phillips 000.

    • Remove 2 screws with a Phillips 0.

    Düzenle

  7. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 6, 1 resimden 1.

    • Disconnect the connector.

    • Disconnect the connector.

    • CCD of the camera

    • Do not touch the CCD. If finger prints got stuck it will be difficult to clean.

    Düzenle

  8. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 7, 2 resimden 1. Eufy Video Doorbell 2k (Battery-Powered) Teardown: adım 7, 2 resimden 2.

    • Battery details and specification.

    • You can use a multimeter to check the voltage of the battery. Mine was still good at 3.9V. Unfortunately the chip got fried.

    Düzenle

Yazar

1 tane daha katılımcı ile

Muzaffar

Üyelik tarihi: 05/12/19

145 İtibar

1 Kılavuz yazıldı

Rozetler: 0

9 Yorum

Goodacternoon po Maam/Sir?

pwedi poba mag order board lang

LAMPUTE VENT - Yanıt

And what happends next?

kubakumate - Yanıt

This is great. Any suggestions for sourcing a new battery pack?

Tezza - Yanıt

My battery may be shot. Same as in pics. Where can I get a replacement?

Joe Guy - Yanıt

I tried changing the battery in mine. Got it sourced individual cell and attached to the existing points (by removing old cells). It got really hot. Seems my chip got fried as well. Not sure how to check if there is anything else faulty than BAttery Chip?

Rishi Gaurav Gupta - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 gün: 11

Son 30 gün: 32

Her zaman: 3,234