Giriş

This guide provides step-by-step instructions on disassembling the Picstart Plus development programmer.

Bu teardown bir tamir kılavuzu değildir. Picstart Plus Development Programmer cihazınızı onarmak için, servis kılavuzumuzu kullanın.

  1. Remove 4 Phillips screws located on the back side of the holding plate.
    • Remove 4 Phillips screws located on the back side of the holding plate.

    • After the screws are removed, remove the case of the development programmer.

    • Carefully take out the circuit board with component side facing up. Put the case aside.

    Yorum Ekle

  2. Disconnect the microcontroller module from the main board using a spudger or a similar tool.
    • Disconnect the microcontroller module from the main board using a spudger or a similar tool.

    • Set the microcontroller module aside.

    Yorum Ekle

    • Flip over the mainboard so that the component side is facing down and remove the small Pan head screws that holds the cover of the IC holder

    • Remove the cover of the IC holder.

    Yorum Ekle

    • Remove the IC holder lever along with the small metal plate that covers the lever.

    • Set the lever and the lever cover aside.

    Yorum Ekle

    • Congratulations! You have completely dismantled the PICSTART Plus Development Programmer!

    • All the extracted components are shown in the picture.

    Yorum Ekle

Brad

Üyelik tarihi: 17-11-2013

624 İtibar

2 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 4

Son 30 Gün: 16

Her zaman: 1,444