Üzerinde Çalıştığım Teardown'lar
Blows air but Does not oscillateFan works, both speeds, but does not oscillate from side to side when button depressed.
HP P1005 LaserJet printing with streaks on paper, Cleaning?This printer was relatively inexpensive and is great for documents in Black & White. Quick, efficient and cheap to...
"MacBook Pro takes hours to turn on after battery drain" için yanıtOn all my Mac Noteboks, an I-book G4 and an Intel Macbook, there is a round ‘Button’ cell soldered in on the m,ain board which retains rudimentary start up information. I have replaced this cell on both my laptops after about 5-7 years, which seems to have solved similar problems to what you are experiencing.
"After SSD installation HDD prox. Sensor is at 249°C; Fans running high" için yanıtWhen I replaced the HDD on my I-Mac, Intel Core i3 running at 3.06 Ghz, there was a small molex type connector on the main board, right near the hard drive, which in my teardown instructions was labelled as 'Internal Temperature Sensor'. They had cautioned me, in the instructions, on removing this connector to gain access to the HDD as the solder connection on the main PCB could crack during removal. Check the solidity of this connector because, if it is broken, it will give a false signal to the Fan Controller circuit. If it has to be re soldered, you have to gain access to the bottom of the board. There is also a utility that you can download, called SMC FanControl, which allows you to set the cooling fan ON and Off temperature in the i-Mac. I used this utility to maintain my internal temperature to no mare than 120 Degrees Fahrenheit, as the iMac would start to get 'Flaky' at about 140 degrees. Update: Well, as I had used the same instructions when I took apart my i-Mac, I don't remember seeing or...
"Why does my iMac suddenly restart?" için yanıtI have seen a few of these where the problem was the Power Supply. Look on the 'Apple' site with the serial number of your power supply and then try to swap it out with a rebuilt unit. You can also check the outputs for their proper voltages, all listed on the apple site under 'troubleshooting'. There was a problem reported with a couple of components, that as soon as they heated up, they would short out and the PSU would shut down as a result. According to your display of error messages, this could also be a 'wanky' memory chip that is very voltage sensitive. I would get a good D.M.M. and check the PSU first! Good Luck.
"Does core i3 processor support windows xp & mac OS?" için yanıtUsing Bootcamp, you have to partition your hard drive to accept OSX on one and Widows on another partition, but Intel Based macs, I have 2, can use windows and OS X without any problem.