I am not sure of that exact model but if the hubcap that you are describing is made of rubber, then it should be a little bit flexible. They are held on by a clip I believe. Don't pull it off straight, but try to take it from the side and see if it comes off. You may need to pry it off. I am not sure if this would help but here's the instruction manual: http://www.scribd.com/doc/131909124/l-0207061-CRAFTSMAN-Manual
It is important to not turn on electronics after it has touched water. However if you want a different item than rice to tuck your electronics in you can try the Thirsty Bag.
As rab777hp had said before not turning it on is very important for a device that has recently been under water, or splashed by it. If you want an alternative to his step #2 of putting your electronic in rice you can get the Thirsty Bag which is better than your incredibly edible grocery substitute.
Hi Jordan, If it is the optical drive that you are trying to replace, is shouldn't need a software update in theory. Perhaps there is something else wrong, or there is a problem with the new optical drive. To test wither or not it is the new optical drive that is broken you probably should contact your supplier and see if they can exchange it for you and try again. Or you can get SATA Wondercable plug in the optical drive and see if it runs.
Hi Chris, There is no easy way to interswap your optical drive and hard drive internally. Although the SATA Wondercable will let you plug in SATA harddrives as well as optical drives externally.
Zaman içindeki itibar
İtibar Dağılımı
Etkinlik
Sayı
Delta
Birisi kılavuzunuzu tamamladı
2180
3590
Birisi kılavuzunu beğendi
173
440
Gönderi olumlu oylandı
10
120
Cevap kabul edildi
3
90
Kılavuzunuza bir bağlantı içeren olumlu oylanmış gönderi