"Why does my dishwasher only fill for the initial rinse but not the was" için yanıtBosch SMU68M15AU/80 I had the same problem, the dishwasher will fill on the rinse then dain and run the wash cycles dry. Many of my searching pointed to the water inlet valve that it would get hot then not work properly on the next cycles. Mine was working. No fault is returned on normal or diagnostic cycle. After some more fault finding I found the drain valve on the side tank (left side) was not opening. 240v was going to the valve but it was not opening. When working normally on the rinse it should open when it fills then close and fill the remainder of the tank. The faulty one would stay closed and overflow and fill not via the small water outlet at the bottom but the vent half way up. Replacement was not difficult it twisted clockwise and pulls out. It is in the bottom right of the picture. The part number for the order was 00611316 that did not match what was on the valve, this is a 240v version. Hope helps someone.