Bu kullanıcı henüz profilini doldurmadı.
Sorular
I got an iPhone X to repair which had a damage screen and did not turn on when connected to power so I opted for changing...
Devamını okuI bought two of the same devices off eBay with the intention of repairing them, I have managed to have both MacBook’s...
Devamını okuCevaplar
If you bought it from iFixit just ask them about it, whether it is normal or not. It might be that the screen is faulty and they might have to send you a new one.
Devamını okuIt might just be that the caps lock on that keyboard is faulty, being that the magic keyboard works properly I would say that is the case. You can try removing the keycap and cleaning it.
Devamını okuMight be a stupid question but did you remove the two bottom screws?
Devamını okuIt’s possible that the full storage is causing it to boot loop or not turn on properly, have you tried putting it in recovery mode and updating it with iTunes?
Devamını okuIf the power jack broke half inside I would suggest getting a bic pen, putting glue in the hollow side (the bottom one with no ink) and inserting in so the jack gets inside of it. Leave it dry and after a while take it out slowly. I had the same issue on a MBP and it worked, hope it helps!
Devamını okuTrovi varie risorse online (video etc.) su come fare, comunque in linea di massima usa uno spduger per alzarle dalla parte sotto non sforzando troppo.
Devamını okuLooks like the screen is causing the phone to short or turn off as you indicated, therefore the only solution I see is changing the screen. This is understandable due to the fact that it fell in water.
Devamını okuPer ripristinare il true tone su un display sostitutivo dovresti usare un programmatore simile a questo (https://www.ebay.it/itm/ICOPY-PLUS-2-1-PROGRAMMATORE-TRUE-TONE-RECUPERO-DATI-SENSORE-LUCE-VIBRAZIONE-/283586384732) per copiare i dati dallo schermo originale a quello nuovo. Praticamente tutti i programmatori hanno delle schede intercambiabili così puoi comprare quella compatibile con il tuo dispositivo.
Devamını okuIf you have tried everything else it could be that the HDMI port itself is bad and would need replacing. That would mean removing the existing one and soldering a new one on the mother board
Devamını okuTo have true tone after a screen replacement you should use a programmer like this one https://www.amazon.com/Programmer-Screen-Transfer-Premium-Quality/dp/B086DTZYZB to read the data (serial number etc.) from the original screen to the new one. Most of these programmers have interchangeable boards depending on which devices you need it for.
Devamını okuLorenzo
@lorenzo5
85
İtibar
10
Çözümler
0
Kılavuzlar
Üyelik Başlangıç Tarihi 02/21/13