If u use hot air soldering station be carefful with microphone, put some tape onit to protect it. U need to be carefull with pads, not to make short. Otherwise yout phone will not only be no charging but it wont work. To replace USB connector properly u need microspoce, hot ait station and this soldering iron. Use flux! To replace USB connect with only soldering iron put a lot of soldering on it and use max heat, then with tweezers remove usb connector, clean wholes and solder new one!
Hello, 1. go to Recovery and wipe cahshe. Press power button and volume down at the same time and releas power button once u see Samsung logo. If it doesnt help go to step 2. 2. Flash via ODIN new softwear. Download new softwer from SamMobile, put tablet in Download mode and flash ti. your data should stay but if tablet cant boot do factory reset from recovery
try to do hard reset if it doesnt help take it to the warant HTC is nout user frendly like Samsung or Apple and doesnt allow u to change softwer very easly. Your problem is in Softwer or Harwer, partly u can fix Softwer problem with hard reset but like I said u cant easly change Softwer on HTC by your self. It requires unlocked bootloader and root. Once u unlock your bootloader ou have no waranty anymore. Hope it helps! Cheers
Hello, u have probably demaged home buton FPC connector on MBO, flex cable on metal shield or just home button. To eliminate start from FPC connector on MBO (Mother Board); check for any rip off component and for any demage on connector. Then check the flex cable on metal shield. look closly and u will probably find something. If u dont find it try hard reset. If it doesnt help i will recomend it to take to Apple store, bcs if u change home button touch id will never work again and u will be facing with error 5 on iTunes once u instal new iOS Hope it helps, cheers