Mid 2010 Model A1278 / 2.4 or 2.66 GHz Core 2 Duo processor

792 Soru Tümünü görüntüle

Why not able to format/partition SSD?

i bought an Sandisk SSD (UltraPlus-128GB) and replaced my faulty Hard Disk in my MAC-book Pro.

After install, The device is detected in "Disk Utility", but i am unable to format / Partition the disk.

Error :

Partition failed with the error:

"POSIX reports:The operation couldn't be completed. Cannot allocate memory."

Regards,

Mani

Yanıtlandı! View the answer Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

See if there are jumpers on the drive as it may need to be slowed down to be seen.

Bu yanıt yardımcı oldu mu?

Puan 2

Yorumlar:

Thanks for help...No jumper in this drive... Below is the FYR..

http://www.sandisk.sg/products/ssd/sata/...

any other suggestion ?

tarafından

Yes, it's getting hard finding SSD's that work with SATA I or SATA II interfaces. Many are only able to work with SATA III now (newest models)

tarafından

The SanDisk Ultra Plus Solid State Drive is compatible with SATA Revision 3.0 (6Gb/s) interfaces and is backwards compatible with SATA Revision 2.0 (3Gb/s) and SATA Revision 1.0 (1.5GB/s) interfaces. I

Try replacing the hard drive cable. These cables have become my most common repair. I now keep two each of the 13" & 15" cables in stock. MacBook Pro 13" Unibody (Mid 2009-Mid 2010) Hard Drive Cable

tarafından

Yorum Ekle

Yanıtını ekle

manivannan sozhan sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 5

Her zaman: 988