Ana içeriğe geç

The camera has a 2.7” LCD screen, a 12 megapixel Four Thirds sized sensor, and a built - in flash. Dimmensions are 115 x 72 x 42mm.

16 Soru Tümünü görüntüle

My screen is displaying "Write Protect Error". What does this mean?

My screen is displaying "Write Protect Error". I do not know how to fix this. Please help.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 1
Yorum Ekle

4 Cevap

Filtre ölçütü:
En Yararlı Yanıt

So. If anybody care. Pin of sd-card slot that responsible for write protection just takes off from PCB with contact pad. And there is no any wire to connect to pin. Transitional hole right under contact pad. So, to repair it you need unsolder sd-card slot completely, extract wire from transitional hole and connect it to ground to switch off write protection for ever. Then solder slot back.

Bu yanıt yardımcı oldu mu?

Puan 1
Yorum Ekle

Hi Matthew,

It sounds like you are having issues with your SD Card. You can start your troubleshooting by making sure the "Write protect switch" on the side of your SD Card. If it is in the unprotected position then you should check out the "Write protection error" section of the Troubleshoot page. I hope this helps and good luck!

~Jeff

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

This is how my E-PL1 died. No matter what I did with the SD cards (yes, plural) I couldn't write to them.

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Write protection swith on sd-card is mechanical. Its state is read by swith in sd-card slot. So there is nothing to do with sd-card. I have same problem and some time i has had workaround inserting card proper way, but not today. So, i will disassemble camera and disable this switch totally.

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

Matthew sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 10

Son 30 gün: 43

Her zaman: 2,140