İtibar: 13
1
In the process of removing the logic board the power switch cable was unintentionally ripped from the back of the power switch. Is there any way to remove the switch so I can attempt to resolder the wire to the switch?
Bu iyi bir soru mu?
İtibar: 685,5b
3,4b
1,1b
2,6b
That switch is usually held in place by 3 plastic globs that are integrated into the back frame. I have used a chisel to break them off and then re-glued it back into place after replacing. It not a pretty repair, just a hack.
Bu yanıt yardımcı oldu mu?
This answer is not a very good It is very silly
Well Manuel, just how do you proposed to repair it? Have you even looked at one?
Son 24 Saat: 0
Son 7 gün: 0
Son 30 gün: 1
Her zaman: 232
1 Yorum
Did this solution work? I have the same problem. Any tips?
kbranch tarafından