Ana içeriğe geç

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Soru Tümünü görüntüle
Soru Kapandı

Touch ID not working after replacing metal backplate

I just replaced my iphone 6 metal back plate and now my touch id doesn't work. There is no damage on the touch id flex cable but while I was changing my cracked screen I accidentally ripped the flex cable connected to the bottom of the metal black plate. I though replacing it would work but so far nothing. Any suggestions?

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

2 Cevap

Filtre ölçütü:

as long as you didnt ripped off the actual button cable it should work.

Just do the hard reset on the phone(hold power and home button simultaneously for about 10seconds, until the phone turns off and apple logo appears again)

If that doesnot work you probably didnt click the connection too well, try opening the phone and make sure the connection clicks.

I sincerely hope you havent ripped off the home button.

Let me know how it goes.

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Is the home button flex properly plugged into the new logic board flex? The long one.... Also, make sure the long flex is properly connected to your logic board.

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 4

Her zaman: 391