Eşyalarını Tamir Et Topluluk Mağaza

Released June 2009 / 2.53 GHz Core 2 Duo Processor

170 Soru Tümünü görüntüle
Soru Kapandı

Seçenekler

Why is my hard drive not being recognized after replacing the cable?

I am getting a flashing folder with a question mark in it... This is even after replacing the HDD cable twice for this machine, with supposedly new parts. It boots fine off an external drive, and I have now replaced the cable twice and neither time have I gotten any love. Additionally, I should mention that I don't feel the drive spinning up when I connect the new cables (or old cable). I know the internal drive is good, because it boots other machines with no issues. Any ideas other than try a third cable?

Thanks!

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

In my experience a failed cable on this model will destroy the hard drive completely about 50% of the time. If the new cables you got did not have paper covering on the sticky surfaces they are not new. I also replace these with the widener, more substantial 2012 cable. I put pads on either side of the cable as it comes over the top to protect them from being hit by the bottom cover.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 2
Yorum Ekle

Seçenekler

Just a shot in the dark but I have had times when dirt , dust has got into the conector and caused problems . That said try blowing out the hard drive sata conection with compressed air as well as the outlet on the motherboard. Hope this helps

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1
Yorum Ekle
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 113