Ana içeriğe geç

Repair and disassembly guides and support for dish washing appliances.

699 Soru Tümünü görüntüle

lights flashing nothing wprks

Our whirlpool quiet partner ii dishwashers HEATED WASH, NORMAL, AND CANCEL lights were flashing when we got up this morning. Worked fine yesterday. Tried going through the reset cyle and umpluggong it and going back through reset. At a loss for what to try next any advice?

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 2
Yorum Ekle

2 Cevap

Filtre ölçütü:
Seçilen Çözüm

duane, try to reset your dishwasher first. To reset it, you will have to have the door open. It can not be latched. Press "Heated Dry," "Normal," "Heated Dry," "Normal" within three seconds of the first pressed button. Now close the door, this should reset your dishwasher. For some of the newer dishwasher, those that do not have dedicated 'heat dry' and 'normal' buttons, you push any 3 buttons in the following sequence: 1-2-3-1-2-3-1-2-3, with no more than a second between each button push. That will put the dishwasher in diagnostic mode. Let us know what you get and what exact model your DW is.

Bu yanıt yardımcı oldu mu?

Puan 2
Yorum Ekle

Afternoon all, I have trying that exact solution for the same problem for the same dishwasher model type.

The "Heater Dry" lights up, but not the "Normal". Other lights that show up are "Pots/Pan", "Rinse","Sani-Rinse", "Heater Dry".

When I push the "Cancel/Drain", you can hear the motor runs.

Not sure if I will need to replace the panel, since the lights on "Normal", and "Light" have are not turning on at all

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

duane sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 7

Son 7 gün: 25

Son 30 gün: 94

Her zaman: 13,172