Blade will not engage

Question

Craftsman Riding Mower

Repair information and troubleshooting for Craftsman-brand riding lawnmowers.

555 Soru Tümünü görüntüle

Kerry Neves @yrrek

İtibar: 1

Gönderildi: 20 Şub 2016

Seçenekler

Blade will not engage

I have a 42" lawn tractor (Mod. #247.28901). I was mowing and heard a loud pop. The deck belt cover (metal) on one of the pulleys had broken. I replaced it, but now I can not get the blade to engage. When I move the lever forward, it pulls the pulley correctly to give tension, but it is too loose to engage. I have compared the belt to a brand new one, and it has not been stretched. I can't see any other damage to the deck or the pulleys. Can you suggest where to look, or what to do? Is there a sheer pin somewhere? Could something have been bent? The tractor will roll fine, but I have no blade movement.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır

Puan 0

Yorum Ekle

3 Cevap

Brian Manuel @bouzeo İtibar: 91 3 · Answer 1 · 2016-02-23T23:08:00-07:00

Brian Manuel @bouzeo

İtibar: 91

3

Gönderildi: 23 Şub 2016

Seçenekler

Don't know the make or model but the first thing I would do is take the deck off and fully inspect the damage. Once the deck is off ,look under the mower while running and engage blade ( no blade ,deck is off !) if the pulley that drives the belt turns then you are fine w the drive part. If not a sheer pin is the case on the pulley drive shaft. My guess is one of the slave pulleys got a sheer pin or damaged so it won't turn. Other than making sure you are routing your belt correctly and right size , not much else there. I'd say you damaged a slave pulley or even the deck so the blade won't turn. Turn by hand to see if any problems after you get the deck out , you should get it from there.

Bu yanıt yardımcı oldu mu?

Evet Hayır

Puan 0

Yorum Ekle