Eşyalarını Tamir Et Topluluk Mağaza

MDR-ZX100 ZX Series stereo headphones made by Sony.

20 Soru Tümünü görüntüle

Seçenekler

No sound in left headphone after tripping over the wire

Hi, I have a Sony MDR-ZX110 Headphone, its basically new and have only used it for a couple weeks.

Last night I tripped over the headphones and after reconnecting them sound from the left side had gone. Right side is working perfectly.

I checked the entire wire and kept wiggling it starting at the port all the way up to the speaker connection, at no point did I hear any connection, as is expected with broken wires if at some point a connection is made sound may come back.

I opened the heaphones to reveal the wire connection to the speakers and tested using a multimeter the connections and the port. The left side gave no repsonse on the resistance test indicating a broken connection someplace.

Is there any way to fix this? Thank you

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 1
Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

@farazk86 "expected with broken wires if at some point a connection is made" not necessarily with the type of wires used in those headphones. If the wiring is okay at the driver end, you most likely tore some wires at the connector end which is the most common cause. It is unlikely (but of course possible) that the wires broke anywhere in between. I would suggest that you replace the connector. Check this guide for the repair. Different headphones, same issue.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 4

3 Yorum:

Hi. Thanks for answering. But i followed the guide but still there is nor sound in the left speaker.

I checked the wires with a multimeter. Checking the connections of the wire against the right speaker I see a reading on the multimeter but doing the same on the left speaker I dont get any response.

So I believe the wire is broken.. Are there any solutions to this?

Thank you

tarafından

None other than to replace the wire. You did replace the jack?

tarafından

You can also use a multimeter to test the wires and plugs for continuity to find what's broken.

tarafından

Yorum Ekle

Seçenekler

I have the same problem, did you find a way to fix it yet?

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0
Yorum Ekle

Yanıtını ekle

Faraz Khan sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 6

Son 30 gün: 20

Her zaman: 2,600