Eşyalarını Tamir Et Topluluk Mağaza

Updated version of the original iPad 2, released in March of 2012 with a smaller die processor and updated internal construction. Repair will require the use of heat and careful prying.

73 Soru Tümünü görüntüle

Seçenekler

LCD goes black after replacing the digitizer

Hello all. I came across a problem that had never seen after replacing the digitizer of an iPad 2. The iPad turn on , the Apple logo appears , but after that the screen turns off and no image appears. The iPad still turned on as iTunes recognizes it. Anyone have any idea what might be happening? Thank you.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

Have you tried to disconnect and remove the digitizer to see if screen works ok ?

From there you can tell if the digitizer causing the problem.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

4 Yorum:

Thanks for answer, but even without the digitizer the issue persists.

tarafından

Would you please check if there is anything missing around the connection on the logic board like capacitor or resistor. Sometimes when you push little to hard some small components gets broken and jumps out of the logic board .

tarafından

Thanks for your time, but the iPad is OK now . A friend took it apart and reassembled it and is now working flawlessly. I don't know if he did anything else , because I wasn't around when he did it, but the most important is that the iPad is working again.

Thanks again.

tarafından

Happy to hear that :)

tarafından

Yorum Ekle

Yanıtını ekle

Renato Sandre sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 71