Eşyalarını Tamir Et Topluluk Mağaza

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Soru Tümünü görüntüle

Seçenekler

Touch Id not working after Screen Replacement

After I replaced my screen I got a message that popped up saying touch id unlivable for this device, the home button works perfectly fine but the touch id doesn't I tried to see if the connection was not secure but still nothing. I also tried to wipe the phone and restore it but still not working. If I replace the home button flex cable will it work again?

Update (10/26/2016)

Update I just ordered a Metal Plate with Heat Shield / Home Button Flex Cable Preinstalled i'll update if this fixes the issue

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0

2 Yorum:

Also can I replace the LCD metal back plate with home button flex cable without effecting the touch id?

tarafından

As I said, it is possible, my brother did it. But his Touch ID didn't work for a few days afterwards. I don't know why though, anyway, after that it worked just fine.

tarafından

Yorum Ekle

3 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski

Seçenekler

Are you using the same button? If not, you will not be able to use Touch ID. It has to be the same home button, they are linked with the logic board.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

5 Yorum:

Yes I am using the same button

tarafından

...aren't you tired yet? do something productive.

Disgusting picture. get a life.

tarafından

@darrell_wolfe me? what did i do?

tarafından

@gigabit87898 Not to you. There was a troll here.

tarafından

@tomchai okay, just wanted to make sure i didnt do something wrong :P

tarafından

Yorum Ekle

Seçenekler

You have to find out by yourself, nobody know what you actually did during the repair so nobody know what exactly got damaged. If replacing the bridging flex did not work, you can be sure that it was not the cause.

The most likely cause might be when you pry the Touch ID button off, you bent the cable section too much. SMD ceramic capacitors are extremely suspecitible to chipping when bent.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

2 Yorum:

is it just the home button that is linked to the logic board or is the bridging flex to

tarafından

As I said, you have to find out yourself by elimination.

tarafından

Yorum Ekle

Seçenekler

My brother had this issue once when he had to replace the metal plate of the LCD Display.

Touch ID didn't work for a few days, but suddenly without doing anything it worked again.

If you didn't change your Home Button, nor any other parts linked to the Touch ID, I'd wait a few days and then maybe think other solutions.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0
Yorum Ekle

Yanıtını ekle

Jeffrey claro sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 162