Eşyalarını Tamir Et Topluluk Mağaza

Mid 2010 Model A1278 / 2.4 or 2.66 GHz Core 2 Duo processor

794 Soru Tümünü görüntüle

Seçenekler

No Power to LCD After Liquid Cleaning

I’ve been cleaning a liquid damaged 2010 with 99% isopropyl. It wouldn’t post for ages, but suddenly has started booting fine: works on battery, charges, keyboard and trackpad work, keyboard backlight works, target disk works, Wi-Fi and bluetooth work, etc.

However, there’s no power to the LCD. I’ve cleaned the board connector and cable several more times, but get no joy. Video output works via MDP, but obviously internal LCD would be great.

Any tips on cleaning further? Does the cable look too damaged?

Block Image

Block Image

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

@minacrime

the solder pads on your connector look corroded as well. Since your cable is also corroded, rest assured that the corrosion is in the connector as well. The only proper way of fixing this is by replacing the connector and cable.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 2
Yorum Ekle

Seçenekler

You’ll need to use solder wick and flux to clean off the solder on the connector pads. Hopefully you can salvage the connector and the logic board pads are still good. Often times the corrosion eats through, then you’ll need to patch the pads and/or run jumpers.

As far as the cable it’ll need replacement.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1
Yorum Ekle

Yanıtını ekle

Jon sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 2

Her zaman: 36