My X360 controller somehow doesn’t have the plug where the rumble motors should plug in, and instead it’s just red and black cables soldered in.
It’s quite old so the cable was torn off and I don’t know where they were soldered in originally.
Where to solder the cables for the motor?
Bu iyi bir soru mu?
İtibar: 1,8b
4
3
here ya go. https://imgur.com/a/IbLZIoJ
This is the front side of the board, but all you need to do is flip it. the square pad is the black wire and the red is the round pad right next to it.
Bu yanıt yardımcı oldu mu?
Son 24 Saat: 1
Son 7 gün: 2
Son 30 gün: 12
Her zaman: 141
