İtibar: 25
1
Display fell out while installing a hard drive . Pinns broken on motherboard connector and vertical sync cable broke on display side. Don’t know where wire go. Can I get a new connector and a ne sync cable? Photos attached.
Bu iyi bir soru mu?
İtibar: 785,2b
1,1b
895
2,3b
@kennyz55 connector J9001 is a Molex 53780-8606 ''1.25mm Pitch Wire-To-Board Connector Wafer Assembly for SMT 6 Circuits Right Angle Emboss T/R
CN3 appears to be a Molex as well but you will have to measure the distance between the pins etc. You could most like find a replacement at places like mouser.com or digikey.com as well as many others.
Bu yanıt yardımcı oldu mu?
Will need to buy P/N DF13A-6P-1.25H(76). It appears that the Molex part number 53780-8606 is obsolete.
I ordered the part on 5/24/20 and will try to install it and see if it works.
Bu yanıt yardımcı oldu mu?
How did you get on with this as I have the same problem
Son 24 Saat: 0
Son 7 gün: 4
Son 30 gün: 9
Her zaman: 655
2 Yorum
Did you manage to find a connector for CN3 on backlight board?
Brett T tarafından
Hi Brett, got a spare or repair computer and swapped it.
John tarafından